Readynas 1000s Manual Download
Resetting the ReadyNAS back to factory default will wipe out all configuration and data. Please understand this before continuing. If you choose to continue, here are the steps: • Power down the ReadyNAS. • Locate a pinhole at the lower left corner of the ReadyNAS 600 on the back. On the ReadyNAS 1000S, the pinhole is in the front. On the ReadyNAS NV, the pinhole is on the back next to USB ports. • Get a straightened paper clip and depress the hidden switch in the pinhole while the power is off, and then power on the ReadyNAS, keeping the switch depressed for about 30 secs. • You will see the drive LEDs in the front blink once at about 5 secs and again at about 30 secs. Release the switch at the 2nd blink. There will be a 10-minute window where you can use RAIDar to change the RAID mode and/or select the snapshot reserved space. RAIDar will prompt with “Click Setup”. If you do not click Setup, the installation will begin with the default settings.
ReadyNAS Surveillance Add-on About ReadyNAS Surveillance The ReadyNAS Surveillance Add-on puts network video recorder (NVR) software onto the same ReadyNAS storage system that you can use to store your video data. You use Surveillance to manage your IP cameras, stream video, and store video data. The following. Protect and support your recent NETGEAR purchase. With NETGEAR ProSupport for Home, extend your warranty entitlement and support coverage further and get access to experts you trust. Protect your investment from the hassle of unexpected repairs and expenses; Connect with experienced NETGEAR experts who know your product the best.
Resetting the ReadyNAS back to factory default will wipe out all configuration and data. Please understand this before continuing. If you choose to continue, here are the steps: • Power down the ReadyNAS. • Locate the reset pinhole. • ReadyNAS 600/X6: the pinhole is on the back in the lower left corner. • ReadyNAS 1000S/1100: the pinhole is in the front. • ReadyNAS NV/NV+/Duo: the pinhole is next to the USB port in the back. • Get a straightened paper clip and depress the hidden switch in the pinhole while the power is off, and then power on the ReadyNAS, keeping the switch depressed for about 30 secs. • You will see the drive LEDs in the front blink once at about 5 secs and again at about 30 secs. Release the switch at the 2nd blink. There will be a 10-minute window where you can use RAIDar to change the RAID mode and/or select the snapshot reserved space. RAIDar will prompt with “Click Setup”. If you do not click Setup, the installation will begin with the default settings. Otherwise